Installation Guide

ASSEMBLY INSTRUCTIONS FOR YOUR
BUSTER CHICA
FLOOR LAMP
2080
ASSEMBLY INSTRUCTIONS:
IMPORTANT SAFETY INSTRUCTIONS
*Turn the power off (remove electrical plug from wall outlet)
before replacing light bulb, making sure the bulb has had suf-
cient time to cool down. Do not subject the lamp to any shock
while lit as shattering of bulb may result.
*This portable lamp has a polarized plug (one blade is wider
than the other) as a feature to reduce risk of electric shock, this
plug will t in a polarized outlet only one way. If it does not t
fully in the outlet, reverse the plug. If it still does not t, contact
a qualied electrician. Never use with an extension cord unless
the plug can be fully inserted.
*DO NOT ALTER THE PLUG.
NOTE: Do not connect the electricity until lamp is fully
assembled.
1. Unpack all parts and remove packing materials.
2. Place base (E) on a level surface.
3. Move column (D) toward base (E), pulling wire from below
base (E). Attach column (D) to threaded nipple on base (E) by
turning column (D) in clock-wise direction.
4. Remove ange (A) from threaded socket (C).
5. Slide center ring of shade spider (located inside shade (B))
over threaded socket (C).
6. Thread ange (A) onto socket (C) to secure shade (B) to lamp.
7. Install one (1) 150W MAX Type A bulb into socket (C).
8. Remove protective plastic (F) from polarized plug (G).
9. Insert polarized plug (G) into wall outlet.
10. Use knob (I) to control power to lamp. NOTE: This lamp
uses a full range dimmer switch. Each switch will stop
turning once full illumination is reached. Turn the switch
GENTLY to adjust light intensity. TURNING KNOB (H)
TOO FAR COULD CAUSE THE SWITCH TO SHORT
OUT.
**To clean, use a soft cloth only. Do not use chemical or
abrasive cleaners.**
(F)
(A)
(B)
(C)
(D)
(H)
(E)
(G)