Installation Guide

ASSEMBLY INSTRUCTIONS FOR YOUR
1987
ASSEMBLY INSTRUCTIONS:
(A)
(F)
(G)(H)
(B)
(E)
(C)
OUTLET
BOX
(D)
(E)
FIGURE A
9. Attach ground wire from xture (green or copper in color) to ground wire from outlet box.
10. Attach hot wire from xture (black in color or smooth side of wire) to hot wire from outlet box. Fasten wires together
with wire nut (D) and tightly wrap connection with electrical tape.
11. Attach neutral wire from xture (white in color or ribbed side of wire) to neutral wire from outlet box. Fasten wires
together with wire nut (D) and tightly wrap connection with electrical tape.
12. Gently push wires back into outlet box.
13. Afx back plate (A) to outlet box using mounting screws (C) provided. NOTE: xture can be mounted in vertical
position or horizontal position.
14. Insert four (4) 60W MAX B-11 medium base torpedo bulbs into the sockets.
15. Carefully close metal frame (B), making sure it connects securely with backplate (A).
Caution: To clean, use a soft cloth only. Do not use any chemical or abrasive cleaners.
1. SHUT OFF ELECTRICAL SUPPLY FROM MAIN FUSE
BOX / CIRCUIT BREAKER.
2. Remove all parts from carton. Do not throw away any parts.
3. Set backplate (A) on level surface. Carefully open metal
frame (B).
4. Remove shade stop (F) from one side of metal frame
(B) by removing screws (H) and washers (G). NOTE: Both
sides of metal frame (B) have a shade stop. Only remove
one shade stop.
5. Align glass shade (E) with metal frame (B). Carefully rotate
glass shade (E) into metal frame (B) as shown in FIGURE
A. NOTE: One side of glass shade (E) should rest against
step on shade stop remaining in metal shade (B). Repeat
step for each glass shade.
6. Align loose shade stop (F) with glass shades (E), making
sure step on shade stop (F) rests securely against edges of
installed glass shades (E).
7. Align washers (G) with holes in shade stop (F) and metal
frame (B). Insert screws (H) through openings in washers
(G) and shade stop (F) into threaded holes in metal frame
(B).
8. Lift backplate (A) to outlet box and make proper electrical
connection. A licensed electrician is recommended.
IMPORTANT SAFETY INSTRUCTIONS:
*These instructions are provided for your safety. It is very
important that they are read completely before beginning the
installation of your xture.
*WE STRONGLY RECOMMEND INSTALLATION BY
A LICENSED ELECTRICIAN.
*Turn off power at switch before replacing bulbs, making sure
xture has had sufcient time to cool down.
*DO NOT subject the xture to any shock while lit as
shattering of bulbs may result.
CHASE 24”
BATH SCONCE