Installation Guide

800.877.2376 www.robern.com

Installation instructions

Part no. 209-1278-rB rev. 09/25/17

Vitality Circle

STEP 2 - PREP THE WALL

6. Using the two provided screws, install the bracket onto the bottom of the mirror.

7. Hang the mirror on the cleats and check level, adjust horizontally to desired location. (This may require two people)

8. Mark the location of the bottom bracket on the wall with a pencil.

9. Lift and remove the mirror from the wall to reveal the pencil mark location of the bracket.

10. Uninstall the bracket from the mirror by removing the two screws previously installed during step 6.

11. Using the screw provided, mount the bracket to the wall at the marked pencil location. Do not over-tighten.

12. If no stud is present use the supplied wall anchor. Remove the screw and enlarge hole with 1/4" drill bit. Insert wall anchor and

re-attach bracket to the wall with the screw.

7 8

Mirror

Wall

Cleat

Wall