Installation Instructions

EXAMPLE:
TWO MFC1628 WITH A RF2832 ARC
CENTER MIRROR IS 60" WIDE. LOCATE
THE VERTICAL CENTER LINE 30"
FROM THE LEFT OR RIGHT EDGE OR
CENTER THE LINE OVER THE FAUCET.
IN ADDITION, MARK A HORIZONTAL
LINE WITH A LEVEL AT THE DESIRED
BOTTOM POINT. WATCH FOR FAUCET
CLEARANCE WHEN USING THE RFS SHELF!
RE:flect® Mirror and RFS Shelf System - Instructions
THE RE:FLECT SYSTEM OVERVIEW: WITH THE OPTIONAL RFS SHELF, THE SURFACE MOUNTED RE:FLECT
SYSTEM CONSISTS OF FOUR ELEMENTS:
1. THE SERIES C CABINET. 2. THE RE:FLECT WALL MIRROR
3. THE RFS SHELF 4. THE SK SIDE KIT
IT IS IMPORTANT TO UNDERSTAND THAT THE RFS SHELF BRACKETS MUST BE INSTALLED DURING CABINET
INSTALLATION. SEE PAGE 2, ITEMS C & D. THE RECESSED RE:FLECT SYSTEM CANNOT USE THE RFS SHELF.
A. LAYOUT AND INSTALLATION OF THE RE:FLECT WALL MIRROR.
1. LOCATING THE CENTER OF THE ENTIRE CABINET /MIRROR COMBINATION.
2. PLACE THE TWO "Z" CLIPS ON THE WALL AS SHOWN.
3. TEST FIT THE MIRROR. ADJUST CLIPS IF NECESSARY. WITH A PENCIL, MARK THE LEFT AND RIGHT EDGES OF
THE MIRROR. REMOVE THE MIRROR WHILE INSTALLING THE CABINETS. BE CAREFUL NOT TO CHIP THE EDGES.
SECTION B DESCRIBES RECESSED MOUNTED CABINETS USED WITH THE RE:FLECT MIRROR.
SECTION C DESCRIBES SURFACE MOUNTED CABINETS USED WITH THE RE:FLECT MIRROR.
SECTION D DESCRIBES SURFACE MOUNTED CABINETS USED WITH THE RFS SHELF SYSTEM.
B. RECESSED MOUNTED CABINET LAYOUT AND INSTALLATION.
1. FOLLOW THE ROUGH OPENING GUIDE ON PAGE 3 OF THE CABINET INSTALLATION SHEET AND THE DRAWING
BELOW. BE SURE THE RE:FLECT MIRROR IS OFF THE WALL AND IN A SAFE PLACE BEFORE CUTTING OPENINGS.
•IMPORTANT• DO NOT SECURE CABINETS TO THE WALL UNTIL YOU TEST FIT THE RE:FLECT MIRROR BETWEEN THE
CABINETS. SHIMMING MAY BE NECESSARY UNDER THE RECESSED PORTION OF THE CABINET.
CENTERLINE
BOTTOM OF CABINET/MIRROR
ROUGH
OPENING
ROUGH
OPENING
PAGE 1
BOTTOM OF CABINET/MIRROR
24"
RF40XX
20 3/4"
RF32XX
16 3/4"
RF28XX
14 3/4"
RF24XX
12 3/4"
3/4"
1 3/4"
NOTE:
FOR CUSTOM WIDTH RF MIRRORS
DIMENSION FROM CENTERLINE
TO EDGE OF ROUGH OPENING IS
1/2 MIRROR WIDTH + 3/4"
USE
#10 X 2"
SCREWS
AND
WASHERS
WITH
ANCHORS
PROVIDED
MIRROR WIDTH LESS 6"
RF20XX
10 3/4"
RF16XX
8 3/4"