Installation Instructions
FAIRHAVEN Cabinets 03/30/07
7
Final Assembly
1. Insert clear snap-in Shelf Clips into
the holes on the sides of the cabinet.
See Figure J.
2. Push one side of the shelf into the left or right clip (A).
3. Snap the shelf down into the opposite side (B). If the
shelf is too tight, repeat the process starting from the
opposite side.
4. Install the Shelf Hole Plugs into the unused holes
inside the cabinet by pressing them into the holes.
5. Place the white Screw Head Caps over any exposed
screw heads.
B
A
Doors
The cabinet doors have a three-way adjustment feature.
Height, level, and fi t-to-frame can all be adjusted using a
#2 Phillips Head screwdriver.
HEIGHT: If the door is too high or low, adjust the door
down or up with screw #2 as shown in Figure I. This
screw is located inside the hinge and requires the door
to be opened approximately 90° to access the screw.
LEVEL: If the door is out of level or too close to one
side, adjust the door to the left or right using screw #1 as
shown in Figure I.
FIT-TO-FRAME: If the door opens stiffl y, squeaks, or
rubs against the gasket, adjust the door outwards with
screw #3 as shown in Figure I.
■
■
■
Adjustments & Maintenance
DOOR
HINGE
12 3
ADJUST DOOR PITCH
SIDE-TO-SIDE
USING SCREW #1
MOUNT OR
UNMOUNT
DOOR,
OR ADJUST
FORWARD OR
BACKWARD
USINGSCREW#3
ADJUST DOOR
UP/DOWN
USING SCREW #2
Door “Swing”
Check the swing of the door. The door hinges come with
a 110° black plastic hinge stop so they will not swing into
a light kit. If no light kit is installed, the stop is not neces-
sary and the door can be allowed to swing 170°. If hinge
stops are required, snap the hinge clip over the elbow of
the hinge into the holes located on the hinge.
Figure I
Figure J
Cleaning and Care
The cabinet door and interior are constructed of mirrored
glass and aluminum. Use only a damp cloth to clean.
Ammonia or vinegar-based cleaners can damage
mirrors. A 50/50 solution of water and isopropyl alcohol is
recommended for cleaning the mirrors. A mild detergent
may be used on the surfaces.
When cleaning, spray the cloth, not the cabinet, mirror,
or surround surfaces.
Do not use abrasive cleansers on any part of the cabinet.
NOTE:
Do not store items in the cabinet area directly
behind the hinge as damage may occur to
cabinet or items.