Owner`s manual

ManualsBrandsRoberH.Peterson ManualsHome building and DecorG21-GL-24-12

BURNER INSTALLATION (cont.)

REFER TO THE BURNER PARTS LIST WHEN FOLLOWING

THESE INSTRUCTIONS.

1. MAKE SURE THE FIREPLACE GAS SUPPLY IS

TURNED OFF.

2. Locate the gas-supply stub inside the ﬁ replace and

remove the cap, if attached (reference Fig. 14-1).

CAUTION: When removing the cap, make sure the stub does

not turn, loosening the connection inside the wall.

3. Place the burner system in the ﬁ replace. Center the burner

in the ﬁ replace. (Reference Fig. 14-2 for orientation.)

4. Be sure gas to the ﬁ replace is off. Remove the adapter

that is loosely connected to the ﬂ ex connector (coming off

of the burner system). Attach the adapter to the gas-supply

stub using a pipe compound resistant to all gasses. Tighten

securely. Then attach the open end of the ﬂ ex connector

to the adapter. Tighten securely. (See Fig. 14-1.)

5. LEAK TEST: Turn on the ﬁ replace gas supply, and test

at all connections for leaks using the appropriate soapy

water solution. If bubbles appear, a leak is present. Turn

off the gas and tighten at all connections. Repeat until

no leaks are present. If a leak persists, turn off the gas

supply and contact the local gas company or dealer.

NEVER USE A FLAME TO CHECK FOR LEAKS.

6. Using the appropriate hardware for your ﬁ replace

construction (not included); secure the burner system

into the ﬁ replace ﬂ oor. The unit has two anchoring tabs,

reference Fig. 14-3.

7. Remove the protective coating off of the reﬂ ective rear

panel and front cover. DO NOT use a sharp object to

remove coating. Install the front cover onto the front of

the burner system (see Fig. 14-4).

Turn off the gas supply prior to proceeding.

REMOTE SYSTEM (if equipped)

If the unit is equipped with a remote; read and follow the

separate instructions (packed with the remote) for complete

remote installation.

CONTROL SETTINGS

We recommend that before you install the decorative media,

you familiarize yourself with the control valve layout. This will

help you to be conﬁ dent operating the burner system when

fully installed. See Fig. 14-5 for typical control positions.

Fig. 14-1 Connect gas supply

Fig. 14-2 Overall orientation (24" shown)

Fig. 14-4 Front cover installed

Fig. 14-3 Anchoring tab close up

Flex connector

Adapter

Gas supply stub

Fig. 14-5 Control valve operating positions

OFF PILOT ON

Read settings here