Specifications

1. Calibration via the control board

Press [Enter] and the [Up] and [Down] keys in order to display the following messages: "Col1, Col2, SGob,

rGob,Grot" for very smooth function calibration. Select one of them, press [Enter] and use the [Up] and [Down]

keys in order to adjust their right value from 0 to 255. Then press [Enter] to confirm or [Mode] to cancel and

return to the menu. This can be repeated for each calibration parameter if it is required. When the calibration is

finished, it is necessary to use the "ArES" function in order to write the calibration values to the memory (EPROM)

and to make a reset in order to check the newly adjusted positions of the colour and gobo wheels. When the

reset of the fixture is finished, the display will show the "FCAL" message. Press [Enter] to repeat the calibration

or [Mode] to return to the "AdJ" menu.

2. Calibration via the external controller

Press [Enter] and the [Up] and [Down] keys in order to display the following messages: "Col1,Col2,SGob,

rGob, Grot" - calibration parameters. Select one of them and press [Enter].

Now you can calibrate the colour 1, colour 2, static gobo and rotating gobo wheels by your controller. The DMX

calibration protocol is described in the table.

DMX Calibration protocol:

After having calibrated required functions press [Enter] to confirm (or [Mode] to cancel and return to the menu

without reset by the "ArES" function) and use the "ArES" function in order to write the calibration values to the

memory (EEPROM) and to make a reset in order to check the new adjusted positions of the colour 1, colour 2,

static gobo and rot.gobo wheel and gobo indexing.

DMX chanel Function

1 Colour 1

Calibration 0-255

2 Colour 2

Calibration 0-255

3 Static gobo

Calibration 0-255

4 Rotating gobo

Calibration 0-255

5 Gobo rotating

Calibration 0-255

6 No function

7 Colours 1

8 Colours 2

9Prism

10 Static gobos

11 Rotating gobos

12 Gobo rotation

13 Iris

14 Focus

15 Strobe

16 Dimmer

Standart protocol