Specifications

8
4.4 Replacing the colour lters and gobos
DANGER!
Install the colour lters or gobos with the device switched off only.
Unplug from mains before!
Colour lters
1. Disconnect the xture from mains and allow it to cool.
2. Remove the top plastic cover of the head by loosening the 4 quarter-turn fasteners on the cover.
3. Turn the colour wheel to the desired position.The dichroic lters are xed on the colour wheel by the
magnets.
4. Release the dichroic lter from the colour wheel by inclining it from its position
to break the power of the magnet . Protect the glass lter with a piece of paper or clout.
5. Insert a new dichroic lter into the colour wheel.
6. Place the top cover back before applying power.
Rotating gobos
1. Disconnect the xture from mains and allow it to cool.
2. Remove the bottom plastic cover of the head by loosening the 4 quarter-turn fasteners on the cover.
3. Gently pull up the gobo holder from the rotation gobo wheel .
4. Remove the spring gobo-lock with an appro priate tool (e.g. small-bladed screwdriver) and remove it.
Do not touch the surface of the pattern of the glass gobo.
5. Remove the original gobo and insert the new one (glazy side towards the lamp). Insert the spring-gobo lock
to secure it in the gobo holder.
6. Insert the gobo holder back under the distance slots into rotating gobo wheel .
5. Replace the bottom cover before applying power.