Specifications

31
6.6 Tab "Service"
Adjust DMX Values - The menu allows you to set all effects to desired positions before ne calibration of the
effects .
Calibrations - This menu enables ne calibration of xture effects and download default calibration values.
Calibrate Effects - The menu allows the ne adjustment of effects.
Pan- a pan position ne adjustment
Tilt - a tilt position ne adjustment
Calibrate Colours - The menu serves for adjusting of LEDs saturation to achieve colour temperature
of 5600K for white output.
Red - a red LEDs saturation ne adjustment
Green - a green LEDs saturation ne adjusment
Blue - a blue LEDs saturation ne adjustment
White - a white LEDs saturation ne adjustment
By using these items you can calibrate and adjust effects to desired positions.
Calibration of the pan/tilt via the control board
1. Disconnect DMX controller from the xture and enter the "Calibrate Effects" menu.
2. Use the [up arrow] and [down arrow] to nd "Pan" and touch it to enter the ne effect adjustment screen.
3. Set desired value and save it by touching the [conrm].
4. Repeat steps 2 and 3 for the item "Tilt".
5. After calibrating all effects, touch the [conrm] to save all adjusted values and reset the xture.
Calibration of the colour saturations via the control board
1. Disconnect DMX controller from the xture , open shutter and dimmer and set the Virtual colour wheel channel
to DMX=10 (white 5600K). Aim the light beam on the lux meter (e.g. Minolta CL-200 Chroma meter)
which is placed at min distance of 2.5m from the xture
2. Set the menu item "Colour Calibration Mode" to On (Personality-> Colour Calibration Mode-> On).
3. Enter the menu "Calibrate Effects".
4. Use the [up arrow] and [down arrow] to nd desired colour and touch it to enter the ne effect
adjustment screen.
5. By means of the Red, green, Blue and White items adjust the 5600K colour temperature as exactly as
possible (∆u´v´= 0).
7. After adjusting 5600K colour temperature, touch the [conrm] to save all adjusted values and reset
the xture.
Note: you can also use DMX controler for both calibrations stated above, calibration protocol is the following:
Effect Mode 1 Mode 2 Mode 3 Mode 4 Mode 5
Pan-ne movement channel 38 channel 22 channel 16 channel 11 channel 38
Tilt - ne movement channel 39 channel 23 channel 17 channel 12 channel 39
Red - red saturation channel 40 channel 24 channel 18 channel 13 channel 40
Green- green saturation channel 41 channel 25 channel 19 channel 14 channel 41
Blue - blue saturation channel 42 channel 26 channel 20 channel 15 channel 42
White - white saturation channel 43 channel 27 channel 21 channel 16 channel 43
Load Default Calibrations - The item loads default (factory) calibration values.
Updating software - The menu item allows you to update software in the xture via either serial or USB port
of PC.
The following are required in order to update software:
- PC running Windows 95/98/2000/XP or Linux
- DMX Software Uploader
- Flash cable RS232/DMX No.13050624 (if you want to use a serial port of PC)
- Robe Universal Interface (if you want to use an USB port of PC)
Note 1: Software update should execute a qualied person. If you lack qualication, do not attempt the upda-
te