Specifications

Note: In the case of an interruption of the upload process (e.g. power cut), the xture keeps the updating mode

and you have to repeat the software update again.

7. RDM

This xture supports RDM operation. RDM (Remote Device Management) is a bi-directional communications

protocol for use in DMX512 control systems, it is the new open standard for DMX512 device conguration and

status monitoring.

The RDM protocol allows data packets to be inserted into a DMX512 data stream without adversely affecting

existing non-RDM equipment. By using a special „Start Code,“ and by complying with the timing specications

for DMX512, the RDM protocol allows a console or dedicated RDM controller to send commands to and receive

messages from specic moving lights.

RDM allows explicit commands to be sent to a device and responses to be received from it.

The list of commands for Robin 100 LEDBeam is the following.

Parameter ID Discovery command SET command GET command

DISC_UNIQUE_BRANCH *

DISC_MUTE *

DISC_UN_MUTE *

DEVICE_INFO *

SUPPORTED_PARAMETERS *

SOFTWARE_VERSION_LABEL *

DMX_START_ADDRESS * *

IDENTIFY_DEVICE * *

DEVICE_MODEL_DESCRIPTION *

MANUFACTURER_LABEL *

DEVICE_LABEL * *

SENSOR_DEFINITION *

SENSOR_VALUE *

DISPLAY_INVERT * *

DISPLAY_LEVEL * *

PAN_INVERT * *

TILT_INVERT * *

DEVICE_RESET *

DMX_PERSONALITY * *

DMX_PERSONALITY_DESCRIPTION *

STATUS_MESSAGES *

STATUS_ID_DESCRIPTION *

DEVICE_HOURS

PARAMETER_DESCRIPTION *

ROBE_DMX_INPUT * *

ROBE_WIRELESS_UNLINK *

8. Error and information messages

Short Err

The message informs you that short circuit has occured on the LED PCB.

Tilt Err

This message will appear after the reset of the xture if the head´s magnetic-indexing circuit malfunctions (sen-

sor failed or magnet is missing) or the stepping motor is defective or its driving IC on the PCB. The head is not

located in the default position after the reset.