Specifications

3.6. Wireless DMX operation

The external Robe Wireless CRMX-LB100 module allows receiving wireless DMX. This device is equipped

with the Lumen Radio CRMX module and antenna for receiving DMX signal. CRMX module operates on the

2.4 GHz band.

Push in the 5-pin XLR plug (1) into 5-pin XLR sockit (4) and simultaneously locating pin (2) into hole (5) in the

xture. In this way the wireless DMX module is connected with the xture.

NOTE: when you disconnect the DMX wireless module from xture, press and hold lock (5) during getting the

wireless module out.

To link the xture with DMX transmitter.

The xture can be only linked with the transmitter by running the link procedure at DMX transmitter .

After linking , the level of DMX signal ( 0-100 %) is displayed in the menu item “Stat“ (Special -->Vireless --

>Stat).

To unlink the xture from DMX transmitter.

The xture can be unlinked from receiver via the menu item “ Unlink“ (Special-->Vireless -->Unlink.).

Note:Wireless DMX operation is implemented in the processor IC-1 (Info -->Sw Ver). Version of this processor

has to be following:

IC-1 = 2.2 and higher for RGBW version

IC-1 = 1.2 and higher for SmartWhite and Day Light version.

1 - 5-pin XLR (female)

2 - Locating pin

3 - Lock

Robe Wireless CRMX-LB100