Specifications

REDMix3•192

6
Thefixturecanberiggedinanyorientationonatrusswithoutalteringitsoperationcharacteristics.Theholeinthe
mountingbrackethasadiameterof10mm.

Theinstallationofthefixturehastobebuiltandconstructedinawaythatitcanhold10
timestheweightfor1
hourwithoutanyharmingdeformation.

Foroverheaduse,alwaysinstallasafetyropethatcanholdatleast10timestheweightofthefixture.Youmust
onlyusesafetyropewithscrew‐oncarbine.Pullthesafetyropethroughthemountingbracketofthe
fixtureand
overthetrussingsystem.

3.2Changingthelensarray
TheREDMix3•192hasa25°lens‐arraymodulefittedasstandard,andisalsosuppliedwithaglassholderforfrost
filtersandagridmodule.
Ifyouwishtochangethelensmodule,followthisprocedure:
1.Switchthefixtureoff.
2.Shiftthesecuritylock(1)tothe
“open“position(blackmark).
3.Pressandholdthelensmodulelock(2)onthesidecoverofthefixtureheadandgentlyliftthemodule(3)
upwardatthesidewherethislockispressed.
4.Pressandholdthelensmodulelock(2)ontheoppositeside
ofthefixtureheadandgentlyliftthelensmodule
(3)
fromitsplacingandremoveit.
5.Fitthenewlensmoduleintothefixtureheadandgentlypushitdownwarduntilthemodulesnapsin.
Makesurethatthelensmodulelocks(2)areproperlylocked.
6.
Shiftthesecuritylock(1)tothe“locked”position(redmark)tosecurethelensmoduleintheplacing.



Ensurethesecuritylockisinthe“locked”position(REDmark)beforestartingthefixtureoperation.

Itispossibletoinstallaplasticfilmintotheglassholdermodulein
ordertogetfrostlight.
1.Uninstallthe25°lens‐arraymodule(1)asdescribedabove.
2.Inserttheplasticfilm(2)intotheslotsunderpartitionsintheglassholdermodule.
3.Installtheglassholdermodulebacktothefixture´sheadasdescribed above.

