Specifications
11
7.Control board
The control panel situated on the top cover of the REDBlinder 2•48 allows DMX addressing,calling build-in
programs and setting the xture behaviour.
Control elements on the control board:
[MODE] button-leaves menu without saving changes.
[ENTER] button- enters menu,conrms adjusted values and leaves menu.
[UP] button and[DOWN] button- moves between menu items on the the same level, sets values.
After switching the xture on,the display shows the initial screen:
Use [UP],[DOWN] to browse through the menu. To select a function or submenu,press [ENTER].
7.1 Addressing the REDBlinder 2•48
The xture can be uperated in the two modes:DMX mode-xture is controlled via DMX 512 by an external
DMX controller
Stand-alone mode - xture uses build-in programs and is
able to control other xtures in the master/slave chain.
See the chapter "Stand-alone mode" for detail description.
For DMX mode is important the DMX start address that is dened as the rst channel from which the REDBlinder
2•48 will respond to the DMX controller.
Setting the DMX start channel for DMX operating:
1. Connect REDBlinder 2•48 to the mains.
2. Browse through the menu by pressing the [UP] and [DOWN] buttons until the display shows current addres
"A001".Conrm by pressing [ENTER] button and "A001" will start to ash frequently.
3. Use the [UP] and [Down] buttons to select the desired address.
4. Conrm by pressing [ENTER].After having addressed REDBlinder 2•48 , you may now start operating RED-
Blinder 2•48 via your DMX controller.
7.2 Program running
By enter to this menu a complete overview of all programs is offered,from which the program to be run can be
selected by pressing [ENTER] button.Selected program runs in a loop.The xture includes 6 built-in programs
(PrG.1-PrG.6) and 3 free editable programs (EPG.1-EPG.3),each up to 30 steps.Each program step has a fade
time-the time during which effects go to the current step and a Standing time-the time,during which effects
last in the current step.
Programming procedure:
1. Enter "Edit." menu
2. Press [UP] or [DOWN] to select the desired program which you wish to edit and press [ENTER].
3. Press [UP] or [DOWN] to select the desired program step ("St.01" - "St.30") and press [ENTER].
4. Press [UP] or [DOWN] to select the desired item and press [ENTER]-button.Now you can edit by using [UP]
or [DOWN] buttons the DMX values of selected item:
P.End. - a total number of the program steps (value 1-30).This value you must set
before start programming(e.g. if you want to create program with 10 steps,set
P.End=10).
rEd.1 - a red LEDs 1 saturation,value 0-255 rEd.2 - a red LEDs 2 saturation,value 0-255
GrE.1 - a green LEDs 1 saturation,value 0-255 GrE.2 - a green LEDs 2 saturation,value 0-255
bLu.1 - a blue LEDs 1 saturation,value 0-255 bLu.2 - a blue LEDs 2 saturation,value 0-255