Specifications

-Presetting playback

This function allows you to select the the program which will be played in the stand-alone mode after switching

the fixture on( LAAu-function must be "On" in the menu LAPr) .The selected program will be also used for the

operating with the time periods or the light level period( LAAu-function must be "OFF" in the menu LAPr).

Use the [Up] and [Down] buttons to select desired program ("tESt"- bilt-in program) or "OFF" if you don't want to

trigger any program and press [Enter] to confirm or [Mode] to cancel and return to the menu.Selected program

will be played continuously in a loop as long as it appears on the display.

This option should be set "OFF" for all slaves in the master/slave chain by reason of the right program starts.

For example: You have selected program "PrG.3" in this menu and:

This fixture is set as a single fixture (master/slave or controller operating)- the fixture will run its program "PrG.3".

This fixture is set as a master in a data chain- the fixture will run its program "PrG.3".

This fixture is set as a slave in a data chain- the fixture will run its program according to the master(if the master

runs its own program "PrG.1", the slave will run its own program "PrG.1"also).

Note for the controller mode: If the fixture operates in this mode ( DMX controller is connected) and any

program from this menu is selected ,the fixture will start to play the selected program if:

- the fixture is switched on

- the reset command from DMX controller is received

- the timer or light level trigger are active and starts the operation

In all these cases the fixture will not respond to the DMX controller.

-Timer

By this menu you can set one or two periods during a 24 hour time period for the stand-alone operation.For

example ,one period in the morning and one period in the evening.

-Fixture clock

This function allows to set the current fixture time. Use the [Up] or [Down] buttons to set the

hour and press the [Enter]-button.Use the [Up] or [Down] buttons to set the minutes and press the

[Enter]-button to save the adjusted time or press the [Mode]-button twice to cancel and return

to the menu.

-Timer 1 -start

This function sets the start of the time period 1.Use the [Up] or [Down] buttons to specify the

start hour and press the [Enter]-button.Use the [Up] or [Down] buttons to specify the start minute

and press [Enter].

-Timer 1-stop

This function sets the finish of the time period 1.Use the [Up] or [Down] buttons to specify the

stop hour and press the [Enter]-button.Use the [Up] or [Down] buttons to specify the stop minute

and press [Enter].

If you wish to deactivate the Timer 1,set Ont1="Off" and OFt1="Off".