Specifications

- Display intensity

With this function you can adjust the display-intensity from 20% to 100% . Use the [Up] and [Down]

buttons to select the level of the display- intensity and press [Enter] to confirm or [Mode] to cancel

and return to the menu.

- Display-reverse

With this function, you can rotate the display by 180°. Use the [Up] and [Down] buttons to select

"normal display" or "display turned by 180°" and press [Enter] to confirm or [Mode] to cancel and

return to the menu.

- Display-On

This function allows you to keep the display on or to turn Off automatically 2 minutes after last

pressing any button on the control panel. Use the [Up] and [Down] buttons to select "On" if you

wish to keep the display on or "Off" if you wish to turn off automatically 2 minutes after last pressing

any button on the control panel and press [Enter] to confirm or [Mode] to cancel and return to the

menu.

- Blackout during movement correction

The function executes the blackout during the head movement correction (the moving head has lost its right pan/

tilt-position for a short moment). Use the [Up] and [Down] buttons to select "On" if you want to execute the

blackout or "Off" if you don’t and press [Enter] to confirm or [Mode] to cancel and return to the menu.

- PAN/TILT-feedback

This function allows to return the mowing head to the required pan/tilt position after changing the position by

external force (e.g.by stroke). Use the [Up] and [Down] buttons to select "On" if you wish to enable this function

or "Off" if you wish not to return the mowing head to the required position and press [Enter] to confirm or [Mode]

to cancel and return to the menu.

Note: If the feedback was switched Off ,the pan/tilt-position is changed by an external force and the feedback is

switched On again,the moving head might not to be synchronized with the DMX signal.You have to make a reset

in order to synchronize the moving head with the DMX signal.

- Fan speed operating modes

By using this function you can choose 5 types of the fan speed operating modes. Browse through this menu by

the pressing [Up] and [Down] buttons - the display shows step by step these messages: "Auto,HIGH, reG,

LoOF, LoHI". Press [Enter] if you wish to select one of them or [Mode] to cancel and return to the menu.

- continuous controlling of the fan speed without the DMX value

The fans automatically raise their speed in order to control inside temperature of the lighting, if the

temperature inside increases about certain level (the low fan speed reduces the cooling of the

lighting). This cycle can repeat several times until the temperature inside is on suitable level.The initi

al level of the fan speed can´t be adjusted by the DMX.

- high (max.) speed of fans

The cooling fans work on max. speed (max. cooling)