Specifications

5.Control

The IMAGE SPOT 250 AT is controled by the 4-buttons control panel on the front side of the base or by the 6-

buttons infra-red remote controller.

Control panel:

Two LEDs on the control panel display the fixture status. Red LED indicates normal operation after switching the

fixture on.Green LED indicates the lamp is switched on.

Remote control:

The red LED on the remote control indicates if any button is pressed (the signal is transmited).

There are the 2 buttons on the remote control which have no aquivalent button on the control panel:[Power]-button

and [Blackout/lamp Off]-button.

All user options may be set by the buttons of control panel or remote control. In the following text,the symbols

[Up] , [Down], [Enter] , [Mode] mean corresponding buttons on the control panel or remote control.

The IMAGE SPOT 250 AT can be operated with a controller in controller mode or without the controller in stand-

alone mode.

Both modes are described in the texts below.

6.Controller mode

The fixtures are individually addressed on a data link and connected to the controller.The fixtures respond to the

DMX signal from the controller.

Green LED

Red LED

Blackout/lamp Off - brief press makes the blackout

- long press switches the lamp Off

Power -switches the lamp On

Red LED