Specifications
8
under high working places and other endangered areas is forbidden.
The operator has to make sure that safety-relating and machine-technical installations are approved by an expert
before taking into operation for the rst time and after changes before taking into operation another time.
The operator has to make sure that safety-relating and machine-technical installations are approved by an
expert after every four year in the course of an acceptance test.
The operator has to make sure that safety-relating and machine-technical installations are approved by a skilled
person once a year.
The projector should be installed outside areas where persons may walk by or be seated.
Important! Overhead rigging requires extensive experience, including calculating working load limits, installa-
tion material being used, and periodic safety inspection of all installation material and the projector. If you lack
these qualications, do not attempt the installation yourself, but instead use a professional structural rigger.
Improper installation can result in bodily injury and.or damage to property.
The projector has to be installed out of the reach of people.
If the projector shall be lowered from the ceiling or high joists, professional trussing systems have to be used.
The projector must never be xed swinging freely in the room.
Caution: Projectors may cause severe injuries when crashing down! If you have doubts concerning the safety
of a possible installation, do not install the projector!
Before rigging make sure that the installation area can hold a minimum point load of 10 times the projector’s
weight.
Danger of re !
When installing the device, make sure there is no highly-inammable
material (decoration articles, etc.) within a distance of min. 0.4 m.
Mount the projector with the mounting-bracket to your trussing system using an appropriate clamp. The hole
in the mounting bracket has a diameter of 10 mm.
For overhead use, always install a safety-rope that can hold at least 10 times the weight of the xture. You
must use safety-ropes with screw-on carabines. Pull the safety-rope through the mounting bracket and over
the trussing system etc. Insert the end in the carabine and tighten the xation screws.
Adjust the desired inclination-angle via the mounting bracket and x the bracket adjusting screws tightly.
Connect the xture to the mains with the power plug.
4.4 Connection to the mains
Verify the power supply settings before applying power!
Connect the xture to the mains with the enclosed power plug.If you need to install other power plug on the
power cable,follow the identication table below.
The earth has to be connected!
The occupation of the connection cables is as follows:
Cable (EU) Cable (US) Pin International
Brown Black Live L
Light blue White Neutral N
Yellow/Green Green Earth
DANGER TO LIFE!
Before taking into operation for the rst time,
the installation has to be approved by an expert!