Specifications

7
4.2 Changing the power supply setting
The transformer must be connected correctly for the local AC voltage and frequency.
The wrong setting can cause poor performance or demage of the xture.The factory settings are printed on
the rear panel of the xture.
If you want to change the power supply setting,follow the instructions:
1.Disconnect the xture from AC power.
2.Remove the top cover by loosening the 3 quarter-turn fasteners on the top cover.
3.Move the wire on the transformer primary connection block to the position according to the desired
voltage.
5.Put the top cover back before applying AC power.
4.3 Rigging the xture
The installation of the projector has to be built and constructed in a way that it can hold 10 times the weight for
1 hour without any harming deformation.
The installation must always be secured with a secondary safety attachment, e.g. an appropriate catch net.
This secondary safety attachment must be constructed in a way that no part of the installation can fall down if
the main attachment fails.
When rigging, derigging or servicing the xture staying in the area below the installation place, on bridges,