Specifications

6
4. Installation
4.1Fitting/Exchanging the lamp
DANGER !
Install the lamps with the device switched off only.
Unplug from mains before !
1.Disconect the xture from mains and allow the xture to cool at least 15 minutes.
2.To insert the lamp remove the top cover by loosening the 3 quarter-turn fasteners on the top cover.
3.Caution remove the display module (1) by loosening two fastening screws (2).
4.Grasp the lamp by the reector (3) and pull it out of the lamp holder (4).
5.Pull the socket (5) off the lamp.
6.Push socket (5) fully onto the pins of the new lamp.
7.Place the lamp (3) into the lamp holder (4).
8.Place the display module (1) back and tighten the two screws (2).
9.Replace the xture cover and tighten the 3 quarter-turn fasteners.
Do not operate this xture with opened housing-cover!