Specifications

9. Stand - alone mode

The xtures on a data link are not connected to the controller but can execute pre-set program which can be

different for every xture."Stand-alone operation" can be applied to the single xture (the xture may be set

to the master or slave mode ) or to multiple xtures operating synchronously.Effect actions are triggered by

sound,using built-in microphone, or automatically using an internal timer.

Synchronous operation of multiple xtures requires that they must be connected on a data link and one of them

is set as a master ("MSt") and the rest as the slaves ("SLA").Up to 32 xtures can be connected in master/slave

chain.Only one xture can be set as the master.The slaves mimic the behavior of the master.

Important!:Disconect the xtures from the DMX controller before master/slave operating ,otherwise data col-

lisions can occur and the xtures will not work properly!

Time control

The master xture starts simultaneous program start in the other slave xtures.All xtures have a denite, syn-

chronized starting point when playing back their programs.Every xture runs its program repeatedly ,starting

the program step No.1 when requested by the master .

For example:

If the slave xture has a shorter program length, it will continously repeat its program until the master xture

nishes its own program and restarts its program running (slave 1- prog.step 3 will not be nished).

If the slave xture has a longer program length,it will restart at prog. step 1 before it completes all its prog.steps

(slave 2 - prog.step 5 will not be played)- see the picture bellow.

Diagram 2

Diagram 1

Audio control

The sound beat starts program steps simultaneous in the master xture and in the slave xtures.Every xture

runs its program repeatedly ,starting the program step when requested by the master.(Master is controlled by

sound and sends demand on the slaves to move them to the next prog.step).

Operating multiple xtures in stand-alone mode.

1.Select one xture and set it as a master (Menu path: "St.A."--->"St.M."--->MSt).

2.The rest of the xtures set as slaves (Menu path: "St.A."--->"St.M."--->SLA).

3.Build the master/slave chain.(See chapter DMX-512 connection and Master/Slave connection).

4.Activate automaticaly program running after switching the xtures on(Menu path: "St.A."--->"Aut."--->On).