Specifications
14
8.5 Demo-test sequences
Use the item to run a special demo-test sequences without an external controller,which will show you some
possibilities of using the xture.
8.6 Stand-alone setting
Select this menu to set xture behaviour in stand-alone mode.
run --- Running program.Select this menu to run a program in a loop or to generate random effects.
St.M. --- Stand-alone mode.This function allows you to set the xture as master or as slave:
OFF. --- The option disables Master/slave operation.
Mst --- Master. This function sets the xture as a master.
SLA ---Slave. This function sets the xture as a slave.
Aut. --- Automatically playback.This function allows you to play the program automatically after switching the
xture on.The program will be played continuously in a loop.
C.S.A. --- Control of the stand-alone operation.
tIM. --- Time trigger. Select this item to run program by time control.
Au.P. --- Audio trigger program.Select this item to run program by audio control
Au.r.---Audio/auto trigger random effects.Select this item to run random generated effects
by the audio control.If there are no audio impulses present,the xture will generate random
effects.
Pr.E. --- Editing program.Select this menu to edit the program.The xture has one editable program.Each
step has a step time-the time,during which effects last in the current step.
Programming procedure:
1. Press [UP] or [DOWN] to select the desired program step ("E.01" - "E.30") and press [ENTER].
2. Press [UP] or [DOWN] to select the desired item and press [ENTER]-button.Now you can edit by [UP] or
[DOWN] buttons the DMX value (0-255) for selected item:
Gob. - a gobo wheel, value 0-255
r.tG. - a rotation of triangular prism, value 0-255
diM. - a dimmer , value 0-127
COP. - copying the current prog. step to the next prog. step.
tIM. - step time,value 0.0-25.5 seconds
End. - this item stops the program.
Press [ENTER]-button to conrm adjusted value .
3.Select next prog. step and repeat this procedure (steps 1-3).
The number of steps in your program will be determined by the position in which you conrm the "End" for
the end of the program.If you want to extend the program, select "COP." in the last step to copy current step
to the next step.
8.7 Reset xture
Select this item if you wish to make a xture reset.
8.8 Special functions
Use this menu for special services like updating software or effect calibration.
VEr. --- Software version.Select this function to read the software version of the xture processor.
UPd. --- Software update
-Using this function you can update software in the xture via PC and serial link.