Specifications
13
8. Functions of the control panel
The control panel situated on the top cover of the xture offers several features. You can simply set the DMX
address or master (slave) mode,switch On and Off the lamp,run a test,make a reset and also use other func-
tions for setting xture behaviour.
Control elements on the control board:
[ENTER] button- enters menu,conrms adjusted values and leaves menu.
, [UP] button and[DOWN] button- moves between menu items on the the same level, sets values.
In order to leave the menu without saving value,press [UP] and [DOWN ] at the same time.
After switching the xture on,the display shows the initial DMX address:
Use [UP],[DOWN] to browse through the menu. To select a function or submenu,press [ENTER].
8.1 Fixture Address
Use this menu to set the DMX address of the xture which is dened as the rst channel from which the xture
will respond to the controller.
For address setting follow this procedure:
1. Switch On the xture and wait until the xture reset has nished ("rES" is ashing at the display).
2. Browse through the menu by pressing the [UP] and [DOWN] keys until the display shows current addres
"001".Conrm by pressing [ENTER] key and "001" will start to ash frequently.
3. Use the [UP] and [Down] keys to select the desired address.
4. Conrm by pressing [ENTER].
After having addressed xture, you may now start operating xture via your lighting controller.
8.2 Microphone sensitivity
Select this function to adjust the microphone sensitivity from 1(maximum) to 20(minimum).
8.3 Lamp On/Off
Select this item to switch the lamp on/off.
Note:if DMX signal is present on the data link,the lamp will be switched automatically on.
8.4 Lamp preseting
Select this menu to change the lamp "behaviour".
LA.A. --- Strike lamp automatically.Select this function to turn the lamp on automatically after switching the
xture on.
d.OF. --- Lamp OFF if DMX is missing. This function allows you to switch Off the lamp automatically if DMX
signal is missing on the data link.