Specifications

DigitalSpot 7000 DT
95
9. Remove the capture card from its packaging and gently press it
down into the empty PCI slot. Secure the bracket of the card to the chassis
by means of the screw (20) with M3 thread. Screw the supporting spacer holder (16)
back to the chassis
10. Connect the SDI/ASI cables to the capture card. The IN/OUT cable
has a blue sleeve at BNC connector and the OUT cable has a red one.
BNC sockets on the capture card are marked (OUT) and (IN/OUT).
11. Place both top covers of the fixture base back and fasten them by 14 screws.
12. After switching the fixture on, the capture card should be ready for operation.
To activate its SDI or ASI input, set DMX value on the Gobo selection channel at desired gobo layer.