Specifications

DigitalSpot 7000 DT

31. Maintenance

31.1 Replacing the lamp

Turn the power off and disconnect the fixture from the mains. If the lamp is hot, avoid burns by waiting for

approximately 45 minutes until the lamp has cooled.

1. Use the tilt lock button (2) to secure the moving head in a

horizontal position. If you look at the rear cover of the head,

the warning writings has to be in a readable position

2. Remove the rear plastic cover (1) of the head by loosening

the four quarter-turn fasteners (2).

3 Loosen the three quarter-turn fasteners (3) at the rear part

of the projector chassis.

4. Carefully take the projector (4) with the chassis (5) out from

the head. The lamp cover (6) is placed next to the filter

compartment.

5 Loosen the screw and open the lamp cover. Pull out the lamp

by using the built in handle. Do not turn the power on with the

lamp cover removed.

6 Replace the lamp with a new one. Make sure that the lamp is

properly and fully inserted.

7 Close the lamp cover and secure the screw.

8. Insert the projector with chassis back to the head

and secure the three quarter-turn fasteners (3).