Specifications

DigitalSpot 7000 DT

7. Shutting down the DigitalSpot 7000 DT

There are two recommended ways how to shutdown the fixture:

1. A DMX controller can switch off the projector lamp and shut down the fixture with the "Lamp Off, Fixture

Off" option on the control channel 8 (see DMX protocol).

2. The option "Fixture Off" in main menu of DigitalSpot 7000 DT switches off the projector´s lamp and shuts

down the fixture.

After shutting down the fixture switch the power switch on the rear side of the fixture base to the off position in

order to save energy.

Removing power directly without the shutdown procedure

can reduce fixture reliability!

8. Positioning the DigitalSpot 7000 DT

The DigitalSpot 7000 DT is designed to be installed in one of four possible installation locations:

1. Front Table - the fixture is placed near the floor in front of the screen.

2. Front Ceiling - the fixture is suspended upside-down from the ceiling (truss) in front of the screen.

Set Ceiling Projection in the menu Personality ("Personality--->"Projection Presetting"

--->"Ceiling Projection"--->"On")

3. Rear Table - the fixture is placed near the floor behind the screen. Set Rear Projection in the menu

Personality ("Personality--->"Projection Presetting"--->"Rear Projection"--->"On")

Note that a special rear projection screen is required.

4. Rear Ceiling - the fixture is suspended upside-down from the ceiling (truss) behind the screen.

Set Rear Projection in the menu Personality ("Personality--->"Projection Presetting"--->

"Rear Projection"--->"On") and Ceiling Projection ("Personality--->"Projection Presetting"

--->"Ceiling Projection"--->"On")

Note that a special rear projection screen is required.

When determining the position of the fixture and projection screen, you will need to account for the projected

image size, which is directly proportional to the projection distance. There is a chart of 4:3 aspect-ratio screen

sizes with a throw distance ratio of 1.8-2.4 : 1 to assist you in determining the ideal location for your fixture.

Note: There is a tolerance among these numbers due to optical component variations. We recommend that if you

intend to permanently install the DigitalSpot 7000 DT, you should physically test the projection size and distance