Specifications

DigitalSpot 7000 DT
23
Display Adjusting --- This function allows you to change the display settings:
Display Permanent On - This function allows you to keep the display permanent on or
to turn it off after 5 minutes of inactivity of control buttons (wheel)
Display Orientation - Select this function to adjust the display orientation:
Normal orientation - A standard display orientation.
Rotated Orientation - Inverts the display by 180°.
Pan/Tilt Feedback --- This function allows to return the moving head to the required pan/tilt position after
changing the position by an external force (e.g. by a stroke).
Be careful, the Pan/Tilt Feedback OFF is not the standard operation and the head of the fixture can be damaged!
Note: If the feedback was switched off ,the pan/tilt position is changed by an external force and the feedback is
switched on again, the moving head might not to be synchronized with the DMX signal. You have to make a reset in
order to synchronize the moving head with the DMX signal.
Pan/Tilt mode --- Use this menu to set the character of the pan/tilt movement.
Time mode --- Pan and tilt will move with different speeds and they will come at the same
time to the end point (pan and tilt sets its optimal speed).
Speed Mode --- Pan and tilt will move with the same speed as adjusted by the channel 5.
(Pan/Tilt speed). E.g. pan will come to the end point and wait for tilt, which has longer track.
Active Blackout while: --- Use this function if you wish to close the light output during the following events:
During Movement correction --- Select this function to enable the blackout during the head
movement correction (if the moving head lost its right pan/tilt position for a short moment).
Pan/Tilt Moving --- This function closes the light output during pan/tilt changing.
Projection Presetting --- Use this menu depending on the installation location of the fixture:
Ceiling Projection --- When this function is "On", a picture is top (bottom and left) right
reversed.This function enables to project the image from a ceiling mounting of
the DigitalSpot 7000 DT.
Rear projection --- When this function is "On", picture is left (right) reversed.
This function enables to project the image to a rear projection screen.
Throw Optics mode --- Use this menu if an optional optics has been installed in the fixture.
Not installed – the option has to be selected if the fixture is equipped
with the standard optics (throw distance ratio 1.8 – 2.4:1).
Long Throw Optics – the options has to be selected if the optional long
throw optics (throw distance ratio 2.7 – 3.5: 1) has been installed.
Short Throw Optics – the options has to be selected if the optional short
throw optics (throw distance ratio 1.2 – 1.7: 1) has been installed.
Projector Refresh Rate --- Use this menu to change the output refresh rate of the DigitalSpot´s
projector from 60Hz to 50 Hz.
The function should be used in cases when output of the DigitalSpot 7000DT is captured by the
video cameras with a fixed 50Hz refresh rate and they are not allowed to adjust embedded 60Hz
picture refresh rate of the DigitalSpot,in these cases some flickering would be visible in an image.
Note. All fixures used in a show must have the same projector refresh rate setting.
DMX protocol --- Use this menu to set desired number of gobo/video layers and DMX channels.
Set DMX mode --- the item allow you to select a desired number of control channels
No Server - the fixture uses first 22 control channels of DMX chart (1-22).
2 Layers - 113 control channels (1-113).
3 Layers - 141 control channels (1-141).
4 Layers - 169 control channels (1-169)
Protocol Version
--- the item allow you to select a desired protocol version.
Gobo Selection Mode --- Use this menu to select desired sorting of media files in media subfolders.