Specifications

DigitalSpot 7000 DT

The the DigitalSpot 7000 DT is equipped with 8-pin RJ- 45 socket for Ethernet input. Use a network cable category 5

(with four “twisted” wire pairs) and standard RJ-45 plugs in order to connect the fixture to the network.

RJ-45 socket (front view): RJ-45 plug (front view):

1- TD+ 5- Not connected

2- TD- 6- RX-

3- RX+ 7- Not connected

4- Not connected 8- Not connected

Patch cables that connect fixtures to the hubs or LAN sockets are wired 1:1, that is, pins with the same numbers

are connected together:

1-1 2-2 3-3 4-4 5-5 6-6 7-7 8-8

If only the fixture and the computer are to be interconnected, no hubs or other active components are needed. A

cross-cable has to be used:

1-3 2-6 3-1 4-8 5-7 6-2 7-5 8-4

Ethernet operation.

Connect the Ethernet inputs of all fixtures in the fixture chain with the network.

Use the menu "Artnet Settings " to set an IP address , artnet universe and artnet subnet on all fixtures (see the

"Fixture address" menu).

The option “Activate Artnet mode" has to be confirmed in “Artnet Settings ” menu on all fixtures.

Example:

(DMX address=1)

DMX address=1 DMX address=170 DMX address=1

IP address=002.168.002.004 IP address=002.168.002.003 IP address=002.168.002.002

Artnet Universe=2 Artnet Universe=1 Artnet Universe=1

Artnet Subnet=0 Artnet Subnet=0 Artnet Subnet=0