Specifications

DigitalSpot 7000 DT
11
A pair of the Omega holders can be placed in 4 positions on the bottom of the base. Use 2 clamps (not supplied)
with screws M12.
To install the fixture on the truss:
1. Bolt clamp (1) to the omega holder (2) with M12 bolt and lock nut through the hole in the holder.
2. Fasten the omega holders on the bottom of the base by inserting both quick-lock fasteners (3) into the holes
of the base and tighten fully clockwise.
3 . Fasten the safety-rope (4) through the t wo apertures in the bottom of the base and over the trussing system.
Before taking into operation for the first time,
the installation has to be approved by an expert!