Specifications

DigitalSpot 3000 DT II
21
Default IP Address -Preset IP address.
Custom IP Address - The option enables edit all numbers of the IP address.
To set the custom IP address:
1. Select „Custom IP Address” and press the [ENTER].
2. Use RNS wheel to set the first number of the IP address
3. Press the [ENTER] to move on the second number of the IP address
4. Repeat steps 2 and 3 for the third and fourth number of the IP address.
If you want to return back on the previously edited number, press [ESC].
The same way you can set the Netmask Address.
Gateway Address –Option allows to set gateway address.
Set ArtNet Universe - Select this submenu to set a Universe (0-15). The Universe is
a single DMX 512 frame of 512 channels.
Set ArtNet Subnet - Select the option to set Ethernet subnetworks to which the fixture
belongs (0-15)
After setting all Artnet parameters confirm setting by using the function
"Activate Artnet Mode":
Activate Artnet Mode - Data is received from the Ethernet input.
15.2 Fixture information
DMX Values --- Select this item to read DMX values of each channel received by the fixture.
Media Disk Space Usage --- Select the item to read information about the hard disk space.
Free Disk Space --- Select the item to show a size of free hard disk space (MB).
Used Disk Space --- Select the item to show a size of used hard disk space (MB).
Software Version --- Select this function to read the software version of the fixture modules:
Graphic Engine - a graphic software of the fixture.
IC1 Motherboard - a processor IC1 on the main board in the fixture base (the IC1 controls
communication, DMX, fans, temperatures).
IC2 Motherboard - a virtual EEPROM.
IC3 Motherboard - a processor IC3 on the main board in the fixture base (the IC3 controls
pan, tilt, LEDs).
IC1 Headboard - a processor IC1 in the fixture head (the IC1 controls focus and shutter).
GPU Info --- Select the item to read information about graphics processing unit, drivers and type of the projector.
Product IDs --- Select the function to read the MAC address and the RDM UID code.
15.3 Personality
Use this menu to modify DigitalSpot 3000 DT II operating behaviour.
Pan Reverse --- Select this function to invert the pan movement.
Tilt Reverse --- Select this function to invert the tilt movement.
Lamp Presetting --- Select this menu to change the lamp “behaviour”.
Lamp On/Power On - Select this function to turn the projector´s lamp on automatically
after switching the fixture on.
Lamp Off via DMX
- Select this function to switch the lamp off via DMX.
Lamp On if DMX Present - This function allows you to strike the lamp automatically after
26 seconds if a DMX signal is present on the data link.