Specifications

28
After having calibrated required functions press [Enter] to confirm (or [Mode] to cancel and return to the menu
without reset by the "A.rES." function) and use the "A.rES." function in order to write the calibration values to
the memory (EEPROM) and to make a reset in order to check the new adjusted positions of the colour and CMY
wheels.
9. Error and information messages
HEAt
This message appears if you try to switch on the lamp within 5 minutes after having switched it off (the lamp is too
hot).The message will appear on the display if the lamp doesn't ignite within 28 seconds. The WASH 250 will store
this information and automatically ignite the lamp when the 5 minutes period has expired.
Caution: The message is disabled if the lamp light sensor (function "En.Sn.") is switched Off (only if the lamp
was turned Off and On within 5 minutes,the message " HEAt " will appear).
LA.Er.
The ignition of the lamp is seven times unsuccessful (the " HEAt " message appeared six times before), and the
display shows " LA.Er ", meaning that the lamp could be damaged or even missed, the fixture is overheating (this
can occur if the ambient temperature is 45° C or more) or there could be a failure on the ignitor or ballast.
Please place or replace the lamp, check the ambient temperature or contact your dealer if the situation was not
caused by the lamp.
Caution: The message is disabled if the lamp light sensor (function "En.Sn.") is switched Off.
FAn
The message informs you that the fixture was overheating and switched off. This message will appear on
the display if the fan speed operating "LOOF" was selected.
MbEr
This messsage informs you that the main PCB does not communicate correctly with the Control Board.
CoEr (color-wheel error)
This messsage will appear after the reset of the fixture if the magnetic-indexing circuit malfunctions (sensor
failed or magnet missing) or the stepping-motor is defective (or its driver circuit on the main PCB). The color-wheel
is not located in the default position after the reset.
FtEr
This error message informs you that the fixture was overheating (occured if the ambient temperature is 45°
C or more) and that the relay switched off the lamp. This message will appear on the display until the temperature
will be on a suitable level, then the display will show the " HEAt " message meaning the lamp is too hot (explanation
see above).
SnEr
This message appears if the lamp lighting sensor is failed.
Caution: The message is disabled if the lamp light sensor (function "En.Sn.") is switched Off.
PoEr
This message will appear if the fixture was shortly disconnect from the main.
PAEr (PAN-yoke movement error)
This message will appear after the reset of the fixture if the yoke’s magnetic-indexing circuits malfunction
(sensors failed or magnet missing) or the stepping motor is defective. (Or its driving IC on the main PCB). The
yoke is not located in the default position after the reset.
tiEr (TILT-head movement error)
This message will appear after the reset of the fixture if the head’s magnetic-indexing circuit malfunctions
(sensor failed or magnet missing) or the stepping motor is defective. (Or its driving IC on the main PCB). The head
is not located in the default position after the reset.
FrEr
It will appear if the frequency of the main is not standard 50 or 60Hz.