Specifications

Blackout during movement correction

The function executes the blackout during the head movement correction (the moving head has lost its right pan/

tilt-position for a short moment). Use the [Up] and [Down] buttons to select "On" if you want to execute the

blackout or "Off" if you don’t and press [Enter] to confirm or [Mode] to cancel and return to the menu.

PAN/TILT-feedback

This function allows to return the mowing head to the required pan/tilt position after changing the position by

external force (e.g.by stroke). Use the [Up] and [Down] buttons to select "On" if you wish to enable this function

or "Off" if you wish not to return the mowing head to the required position and press [Enter] to confirm or [Mode]

to cancel and return to the menu.

Note: If the feedback was switched off ,the pan/tilt-position is changed by an external force and the feedback is

switched on again,the moving head might not to be synchronized with the DMX signal.You have to make a reset

in order to synchronize the moving head with the DMX signal.

Fan speed operating modes

By using this function you can choose 5 types of the fan speed operating modes. Browse through this menu by

the pressing [Up] and [Down] buttons - the display shows step by step these messages: "Auto,HIGH, reG,

LoOF, LoHI". Press [Enter] if you wish to select one of them or [Mode] to cancel and return to the menu.

Continuous controlling of the fan speed without the DMX value

The fan automatically raises its speed in order to control inside temperature of the lighting, if the

temperature inside increases about certain level (the low fan speed reduces the cooling of the

lighting). This cycle can repeat several times until the temperature inside is on suitable level.The

initial level of the fan speed can´t be adjusted by the DMX.

High (max.) speed of fans

The cooling fan works on max. speed (max. cooling)

Continuous controlling of the fan speed

This mode is similar to "Auto", but the initial level of the fan speed can be adjusted by the DMX.

Low speed/Switch Off the lamp operating

The fan keeps the adjusted low speed until the temperature exceeds max. inside temperature of the

fixture, then the WASH 250 XT automatically switches off the lamp.

Low/high speed of the fan operating

The fan keeps the adjusted low speed until the temperature exceeds max. inside temperature of the

fixture, then the WASH 250 XT automatically switches from low to high the fan speed.

Note:The modes "Auto" and "HIGH" don´t interact to the DMX value on the channel 6 (0-127)!