Specifications

8
4.3 Inserting/Exchanging the gobos
DANGER!
Install the gobos with the device switched off only.
Unplug from mains before!
In order to exchange the gobos open the housing by loosening the fastening screws at the side panels and by
removing the focus-screw and zoom-screw.
If you wish to use other forms and patterns as the standard-gobos, or if gobos are to be exchanged, please follow
the instructions below:
1.Unscrew one of the Gobo-screws and loosen the other two. Replace the desired gobo.
2.Replace the housing cover and tighten the screws.
4.4 Rigging the fixture
Danger of fire !
When installing the device, make sure there is no highly inflammable
material (decoration articles, etc.) in between a distance of min. 0,5 m.
Attach the mounting-bracket to the projector by using the enclosed fixation screws.
Mount the projector with the mounting-bracket to your trussing system. The hole in the mounting bracket has a
diameter of 10 mm.
For overhead use, always install a safety-rope that can hold at least 10 times the weight of the fixture.
Adjust the desired inclination-angle via the mounting-bracket and fix the bracket-screws tightly.
Make sure that the device is fixed properly! Ensure that the structure
to which you are attaching the projectors is secure.
For overhead use, fit a safety chain or cord.
4.5 Connection to the mains
Connect the fixture to the mains with the enclosed power-plug.
The earth has to be connected!
The occupation of the connection-cables is as follows:
Cable Pin International
Brown Live L
Light blue Neutral N
Yellow/Green Earth