Specifications

16
Default settings
Press [Enter] to reset all fixture personalities (not the adjusting functions) to the default values. On the display
will appear "rSt" meaning that the fixture makes the reset. See the table of personality setting and their default
positions.
Adjusting the default positions of colour and effect wheels
By this function you can calibrate and adjust the colour and effect wheels to their standard/right positions. Use the
[Up] and [Down]-keys to browse through the adjusting menu - the display shows step by step these messages:
„CoL, EFEC, Stro, dimr, FCAL“ by which you can adjust the fixture to the required / desired position (0-255)
before the function calibration. Then when the positioning is finished use the last „FCAL“ function (Fixture
calibration).
1. Calibration via the control board
Press [Enter] and the [Up] or [Down]-key in order to display the following messages: „CoL, EFEC“ for very
smooth function calibration. Select one of them, press [Enter] and use the [Up] or [Down]-key in order to adjust
their right value from 0 to 255. Then press [Enter] to confirm or [Mode] to cancel and return to the menu. This can
be repeated for each calibration parameter if it is required. When the calibration is finished, it is necessary to use
the „ArES“ function in order to write the calibration values to the memory (EEPROM) and to make a reset in order
to check the newly adjusted positions of the colour and effect wheels. When the reset of the fixture is finished,
the display will show the „FCAL“ message. Press [Enter] to repeat the calibration or [Mode] to return to the
„AdJ“ menu.
2. Calibration via the external controller
Press [Enter] and the [Up] or [Down]-key in order to display the following messages: „CoL, EFEC“ - calibration
parameters. Select one of them and press [Enter].
Now you can calibrate the colour and effect wheel by your controller. The DMX calibration protocol is described
Personality Display
Lamp on
automatically
Display intensity
Lamp Off via DMX
Fan speed
operating mode
Default values
(SHADED)
Automatic blackout
of display