Specifications
16
Shutter/Strobe
Extremely fast shutter is also used for strobe effect (1 - 10 ashes per second)
7. Stand - alone mode
The xtures on a data link are not connected to the controller but can execute pre-set programs which can be
different for every xture.To set the program to be played,see the "Stand-alone setting" ( menu "St.AL.").
"Stand-alone operation" can be applied to the single xture (the xture may be set to the master /slave mode
or controller mode ) or to multiple xtures operating synchronously.
Synchronous operation of multiple xtures requires that they must be connected on a data link and one of them
is set as a master (master mode) and the rest as the slaves (slave mode).The slaves are assigned to SLA1-
SLA9 and on the certain slave address can be connected only one xture.To set the xture as the master or
slave , see the "Addressing" (menu "A001").Only one xture can be set as the master.
If the master xture runs a reset,switches On/Off the lamp or plays test(program) ,all slaves will execute
these acts too (e.g. if the master xture has switched the lamp off,no slaves can switch the lamp on)!
The master xture starts simultaneous program start in the other slave xtures.All xtures have a denite, syn-
chronized starting point when playing back their programs.The number of running program is the same in all
slaves and depends on the master's choice (menu "St.AL." ).Every xture runs its program repeatedly ,starting
the program step No.1 when requested by the master .
For example:
If the slave xture has a shorter program length, it will continously repeat its program until the master xture
nishes its own program and restarts its program running (slave 1- prog.step 3 will not be nished).
If the slave xture has a longer program length, it will restart at prog. step 1 before it completes all its
prog.steps
(slave 2 - prog.step 5 will not be played)- see the picture bellow.
Note:Disconect the xtures from the DMX controller before master/slave operating ,otherwise data collisions
can occur and the xtures will not work properly!
Starting point
Restart