Operation Manual

15. GENERAL SAFETY ADVICE
• Neverplace the charger and connected batteries on combustible surfaces.
• Never operate the unit in the vicinity of inflammable materials or gases.
• Donot leave the device unattended when in use. . The charger can heat up consi-
derably during normal operation.
• Checkfordamagetothecasingandleads.
• Takeparticularcarewhenhandlingbatterypackswithalargenumberofcells.Ensure
good insulation to prevent the risk of electric shock.
• ThePowerPeak®
®
Twin EQ-BID is designed only for charging, discharging and equa-
lizing rechargeable NC/NiMH/lead and lithium batteries. Due to the risk of explosion,
do not use the charger to charge dry batteries.
• Thechargerisdesignedforoperationonlyfor11-28DCoperation,therefore,never
operate the charger with a different voltage supply.
• Protectthechargerfromdust,dirtandmoisture
• Donotexposethechargertoexcessivelyloworhightemperaturesaswellasdirect
sunlight.
• Makesurethechargerisnotexposedtoimpact,pressureorexcessivevibrationload.
• Ensurethecoolingventsarealwayscleartoallowairtofreelycirculate.
• Whennotusedforalongperiodsoftime,unplugthechargerfromthepowersourceand
disconnect any batteries.
• Donotchargerechargeablebatteriestwiceinquicksuccession.
• Donotchargebatteriesthatareatahightemperature.Allowbatteriestocooldownto
ambient temperature.
• Onlycellsofthesamecapacityandofthesamemakemaybechargedtogether.
• NeverchargetwoNC-NiMHbatteriesconnectedinparalleltooneoutput,connectonly
one rechargeable battery pack at a time.
• Ensurecorrectpolarityofthebatteryandavoidshort-circuits
• Closelyfollowtheinstructionsprovidedbythebatterymanufacturer.
• • AlwaystakegreatcaretocheckthesettingsonthePowerPeak®
®
Twin EQ-
BID. Incorrect settings can damage the batteries beyond repair.
Operating Instructions
Power Peak
®
Twin EQ-BID
31
Autobatterie
Lader
Akku
Autokarosserie
Ausgang nicht mit Eingang verbinden.
!