Operation Manual

10. PROGRAMMING THE BIT CHIP / KEY “EDIT BID”

To configure the connected BID chip / key you have to select the “EDIT BID” menu. The

following parameters can then be set:

SETTING THE BATTERY TYPE AND THE CELL COUNT

At this point you can set the battery type and the

associated cell count. Pressing the “ENTER” button

selects the first parameter ‘Battery type’. You can

now set the desired type using the “+” / “-” buttons

or the “SELECT WHEEL”. Pressing the “ENTER” button again accepts the selected type,

and automatically moves on to the second parameter ‘Cell count’. The number of cells in

the pack can now be selected using the “+” / “-” buttons or the “SELECT WHEEL”. Finally

the “ENTER” button must be pressed in order to accept your selected data.

SETTING THE BATTERY CAPACITY

When you press the “ENTER” button the variable

parameter flashes. You can now select the appro-

priate battery capacity using the “+” / “-” buttons or

the “SELECT WHEEL”. Press the “ENTER” button

again when you are finished.

SELECTING THE CHARGE CURRENT

This parameter is used to set the charge current;

pressing the “ENTER” button selects the parameter.

You can now set the desired charge current using

the “+” / “-” buttons or the “SELECT WHEEL”.

Pressing the “ENTER” button again accepts your selected value. Note that the maximum

charge current varies according to the cell count and / or the battery voltage. The charg-

er’s integral processor limits the maximum charge current.

SETTING THE DISCHARGE CURRENT

This parameter is used to set the discharge current;

pressing the “ENTER” button selects the parameter.

You can now set the desired discharge current

using the “+” / “-” buttons or the “SELECT WHEEL”.

Pressing the “ENTER” button again accepts your selected value. Note that the maximum

discharge current varies according to the cell count and / or the battery voltage. The

charger’s integral processor limits the maximum discharge current.

Operating Instructions

Duo-Power 8S EQ

No.

8504