Operating instructions

Telemetry-Box 2.4 GHz FASSTest
®
13
WARNINGTONE:
Here you can select a sound which provides an audible
warning that the MIN VALUE has been reached.
Adjustment range: 0 ... 29
MAX VALUE:
At this point it is possible to select a maximum value, which
triggers an on-screen warning, the vibration alarm and an
audio alarm when it is reached.
Note:
The alarm can be switched off at any time using the "ESC"
button. If it is not switched off, it continues to sound for the
period of time defined under "WARNING DURATION".
Adjustment range: Sensor-specific
WARNINGTONE:
Here you can select a sound which provides an audible
warning that the MAX VALUE has been reached.
Adjustment range: 0 ... 29
>WARN DuRATION: 10S
REPEATTIME: 2M
FACTORY SET:
WARNINGDURATION:
The "WARNING DURATION" function is used to set how
longthesignaltonefortheminimumvalue(sink)andma-
ximum value (climb) is to last.
Adjustment range: OFF ... 30s
REPEATTIME:
If you wish a "Min." or "Max." value to persist even after the
set "WARNING DURATION", you can enter a time at this
pointatwhichthesignaltoneforsinkorclimbistriggered
again.
Adjustment range: OFF ... 30s
FACTORY SET:
Holding the "ENT." button pressed in for about two se-
conds, resets all parameters.