Operating instructions

Telemetry-Box 2.4 GHz FASSTest

Thevolumeofthespeech outputcan beadjustedinthe

Volume display.

Hold the "ENT." button pressed in to move to the Set-up

menu.Thescreendisplaynowlookslikethis:

The volume can now be changed using the "+" and "-" but-

tons.

Note:

The Volume setting only applies to speech output; The vo-

lume of the button beep is not affected by any change you

makehere.

In the Speech Output display you can set which sensor

data are to be generated in speech output form.

In its basic form this display is always the same; it only

varies by differences in the sensor names.

The sequence of the displays may also vary, depending on

whether the sensors are switched on or off in the "SEN-

SOR SETTING" menu under the "SPEECH" option.

Hold the "ESC." button pressed in to move to the Speech

Outputdisplay.Thescreendisplaylookslikethis:

The desired sensor for speech output can be selected

using the "+" and "-" buttons, as described in chapter 5.

Please note that only the data from one sensor can be ge-

nerated as speech output. The other sensors, such as the

Vario, are then generated using the Melody function (see

page 9).

A:ON MODEL0 SPH/ ON

RECEIVER BATTERY

12. EXPLANATION, SPEECH OUTPUT DISPLAY 13. EXPLANATION, VOLUME DISPLAY