Datasheet

16
Re-binding the transmitter
This procedure is only necessary after replacing individual components.
Move the throttle stick to the Idle position.
Hold the throttle stick pressed in while you switch the transmitter on (Fig. 1). The
screen now flashes. Slide the LiPo battery into the model.
Note: if you have converted the transmitter to Mode 1, you must press in the
right-hand stick (Fig. 2).
When the re-binding process is complete, the screen stops flashing and reverts
to the normal display (Fig. 3)
Fig. 1
Fig. 2Fig. 3
Operating instructions - ARCUS E-RISE 500 RTF 2.4 GHz No. 2562