Datasheet

13
Flight preparation
Switch the transmitter on (Fig. 1). The battery status is
shown on the left of the screen. Move the throttle stick
and trim to the lowest position. Slide the fully-charged LiPo
flight battery into the holder in the bottom of the fuselage
(Fig. 2).
The transmitter and the receiver are now ready for use.
Repeat this procedure every time you wish to fly the model.
The Centre of Gravity (see illustration on page 15) is che-
cked by supporting the model under the wings on both
sides of the fuselage using your index fingers, and allow-
ing it to hang freely. Ideally the model will now balance
level, with the nose inclined slightly down.
Note: the 2.4 GHz transmitter and receiver are supplied
already bound at the factory. It will only be necessary to
bind the system again after a repair, or if you replace a
component.
The correct pre-flight procedure.
Fig. 1 Fig. 2
Checking the working systems
Before the first flight it is important to set all the trims - ex-
cept for the throttle trim - to centre. The throttle stick must
be in the "fully back" position (towards you). If the propeller
turns, adjust the throttle trim until it comes to a halt.
The correct post-flight procedure.
Remove the flight battery from the holder in the bottom of
the fuselage, then switch the transmitter off.
Preparations for the first flight:
Wait for a day with absolute flat calm conditions.
Charge the flight battery before flying.
Operating instructions - ARCUS E-RISE 500 RTF 2.4 GHz No. 2562