Datasheet

10
"Primary" and "expanded" control function setting
The transmitter offers the facility to adjust the sensitivity
of the stick movements. We recommend "softer" reduced
travels for beginners.
Open the transmitter battery compartment and insert the
four AA cells* (check for correct polarity).
Switching sensitivity:
Switch the transmitter on, and
press the right-hand stick in.
If you have converted the transmitter to Mode 1, the left-
hand stick must be pressed in.
* Please read the information regarding dry cells on page 4.
Reduced control function
The full black disc on the
"Dual-Rate status indicator" disc is
reduced to half.
Enlarged control function:
Press the right-hand stick in again.
The full black disc on the
screen now reappears.
Mode 2
Converting the transmitter from "Mode 2"
(throttle left)
to "Mode 1" (throttle right)
The transmitter is supplied set to Mode 2 as standard. If
you prefer Mode 1 and wish to convert the transmitter to
that mode, use this procedure:
The transmitter must be switched off.
Release the clip over the aerial
using a cross-point screwdriver.
Raise the aerial out of its recess and
set it at 90°.
Now turn the aerial through 180°
and place it in the recess again,
pointing in the opposite direction.
Place the clip over the aerial and
screw it in place. Re-positioning
the aerial in this way shifts throttle
control to the right-hand side.
Switch the transmitter on, and pull
the throttle trim back (towards you).
Check the new stick mode (Mode 1).
Operating instructions - ARCUS E-RISE 500 RTF 2.4 GHz No. 2562