Instructions for use
ENGLISH
23
INSTRUCTIONS AND USER MANUAL
5. Programming the ESC with the transmitter (4 steps)
Note: Please note that the throttle curve is set to 0%, the throttle lever to neutral positi-
on and the deection to 100%.
1. Start programming mode
2. Select program point
3. Setting the program point (value)
4. Exit programming mode.
1. Start programming mode
1) Switch on transmitter, set throttle stick to full throttle, connect battery to ESC
2) Wait 2 sec., a double „beep“ must be heard
3) Wait another 5 sec., special tone like “♪56721” should be heard. This conrms
the programming mode.
3. Setting the program point (value)
You hear different tones in a loop. Set the value by tone by moving the throttle to
full throttle. Then you hear a special tone „♪1515“ which conrms and saves the
selection. (Holding the throttle to full throttle brings you back to step 2 and you
can select another point. Moving the throttle lever to the neutral position within 2
seconds will exit the programming mode.)
Point Tone
“beep-” “beep-beep-” “beep-beep-beep”
1 short tone 2 short tones 3 short tones
Brake Off On
Battery type Lipo NiMH
Cut-Off Soft-Cut Cut-Off
Cut-Off voltage Low Medium High
Start mode Normal Soft Super Soft
Timing Low Medium High
2. Select program point
After starting the programming mode you will hear 8 tones in a loop with se-
quence. If you move the throttle to the neutral position within 3 seconds after
listening to a tone, this point will be selected.
1. “beep” Brake (1 short tone)
2. “beep-beep-” Battery type (2 short tones)
3. “beep-beep-beep-” Lower voltage (3 short tones)
4. “beep-beep-beep-beep-” Cut-Off voltage (4 short tones)
5. “beep-----” Start Mode (1 long tone)
6. “beep-----beep-” Timing (1 long 1 short)
7. “beep-----beep-beep-” Factory reset (1 long 2 short)
8. “beep-----beep-----” Exit (2 long tones)
4. Exit programming
There are two ways to exit the programming:
1. In step 3, after the special tone „♪1515“, move the throttle stick to the
neutral position within 2 seconds.
2. In step 2, after tone „beep-----beep „ (e.g. point 8) bring throttle stick
inner 3 sec. Into neutral position.