Instructions for use

14
ASSEMBLY THE WING
ARF: Install the servo in the servo opening.
We recommend the use of a designated
servo frame. Use a wire to route the servo-
cable through the servo openings. The green
6-pole MPX plugsystem is used to connect
the fuselage.
11
Connect the aileron rods to the rudder- and
servo horns (outer servo). Make sure that
the rudder is placed in neutral posion du-
ring right-angled posion of the servohorn. If
needed, adjust the rods.
ARF: Install the servo in the servo opening.
We recommend the use of a designated
servo frame. Use a wire to route the servo-
cable through the servo openings. The green
6-pole MPX plugsystem is used to connect
the fuselage.
09
Pay aenon to a proper cable guide. Stash
the excessive length of the leads away in the
cable conduits.
12
The linkage of the aps is realized by a cross-
over connecon through the surface of the
wing. Therefore the rod must inially be con-
nected to the boom side of the ap servo
and routed through the upper side of the
wing in order to be connected with the ap`s
rudder horn. If the servo horn is posioned
in a right-angle (neutral posion), the deec-
on of the ap should read approximately
15mm downwards.
10
ENGLISH