Instructions for use

ENGLISH
14
INSTRUCTIONS AND USER MANUAL
Modellsport
14
15
16
17
18
19
20
14
15
16
17
18
19
20
WING
ARF
The following descriptions refer to both ailerons, but
are shown on one side only.
Screw the brass rudder horn with Loctite in the ai
-
lerons. Milling a small notch in the wing, so that the
rudder horn does not start at the rudder deection
down.
ARF
Also sand the bottom of the servo opening in the
wing well with coarse sandpaper.
ARF
Shrink the two servos and grind the underside well.
Trim the servo horn as shown and drill the second
hole from inside to 1.6mm. The hole distance is here
about 9mm. Put the servo in neutral position and
screw the horn.
ARF
Take two 25cm length servo extension cables and
connect them to the servos. If MPX connectors are
to be used later for connection to the wing, leave
the other side of the cable unplugged.
ARF
Thread the extension cables through the wing. If
necessary, solder the MPX connectors.
ARF
Align the servo by sliding it in the slot so that the aileron is neutral when the servo horn is neutral. In order to t the cover later, the linkage must also be
perpendi-cular to the aileron. After aligning, x the servo with a mounting clamp. Then use a cannula to apply thin superglue between the servo and the
wing. Alternatively, the bonding can also be done with good resin, the alignment then takes place after application of the resin.
Make sure that the servo is perfectly glued to the wing! A faulty gluing can represent a safety risk and cause personal injury as well as property
damage, and the linkage must also form a parallel line to the servo in order to ensure the smoothest possible and most precise linkage! This can
signicantly inuence the later ight characteristics.
ARF
Make the link with two clevises and one M2 threa-
ded rod. The clevises are screwed directly to each
other due to the small space and secured with
Loctite.
Connect the linkage with servo and rudder horn.
ARF PNP
Make/take two additional extension cables of
approx. 15cm, which serve as a patch cable to the
receiver.