Instructions for use

ENGLISH
11
INSTRUCTIONS AND USER MANUAL
Modellsport
PREFACE
Congratulations on your purchase of the new RAT.
The RAT is a high-quality FRP pylon speed model, which we have developed for experienced and
ambitious model aircraft pilots.The construction of such a model and related detailed solutions are
subject to a certain taste dependency. Therefore, the solutions of this manual are to be understood
as a suggestion. The PNP version (Plug and Play) is already very much prefabricated. The ARF version
(Almost Ready to Fly) requires model-building experience and basic technical skills in construction.
In any case, there are different ways and approaches to get a very good ying model. Some alter-
natives are therefore discussed during the construction description, but not shown in the picture.
PLEASE READ THE INSTRUCTION VERY CAREFULLY COMPLETE BEFORE STARTING!
TECHNICAL DATA
BOX CONTENT / NEEDED ACCESSORIES
FLIGHT INSTRUCTIONS
• Before the rst ight, observe the instructions in the „Safety Instructions“ section.
• When ying the model, you should choose a day with as little wind as possible
• A large, at area without obstacles (trees, fences power lines etc.) is suitable for the rst ights.
• Please carry out a functional test of the drive train / power set and remote control.
• After assembling the model on the aireld, check once again that all model components such as
wing, tail units, wing mounts, engine, linkages, etc. are rmly and properly fastened.
• For a hand start a helper should be present, who can throw the model with enough thrust into the
air.
• The start usually takes place against the wind.
• Do not stall the model near the ground
• Do not initiate tight turns in the immediate vicinity of the ground.
• Check the reactions of the model to the rudder deections. If necessary, adjust after landing to
increase or decrease the deections accordingly.
• The minimum ight speed must be at an adequate safety altitude.
• Initiate the landing with sufcient speed
SAFETY INSTRUCTIONS FOR RECHARGEABLE BATTERIES
• Do not immerse the battery in water or other liquids.
• Do not heat, throw into re or microwave.
• Do not short-circuit or charge with reversed polarity
• Do not expose, deform or throw the battery
• Do not solder directly on the battery
• Do not change or open the battery
• Only charge the battery with suitable chargers, never connect it directly to a power supply unit.
• Never charge or discharge the battery or charger on a ammable surface.
• Never leave the battery unattended during charging or discharging processes.
• Never charge or discharge the battery in direct sunlight or near heaters or re.
• Do not use the battery in places subject to high static discharge.
All this can cause the battery to be damaged, explode or even catch re!
• Keep the battery away from children
• Keep leaked electrolyte away from re, as it is highly ammable and may ignite.
• The electrolyte liquid should not get into the eyes, if it does, rinse immediately with plenty of clear
water and then see a doctor.
• The electrolyte liquid can also escape from clothes and other objects with a lot of water or was
-
hed off.
• Observe the safety instructions of the battery manufacturer and the charger manufacturer.
Span 1300 mm
Length 730 mm
Weight (dry) 420 g
Flying weight 1050 g
Wing Area 16,8 dm²
Airfoil MH-43
C.G. 47 - 52 mm
Elevator yes
Rudder no
Ailerons yes
Flaps no
Flaps no
Motor yes
Landing Gear no
ARF PNP
Motor not included Robbe ro-Power X36-1000 #5805 (built-in)
ESC not included RoControl 6-60 #8711 (not included)
Folding Prop not included Rasa CFK 9x7“ (included))
Spinner not included Alu Turbo Spinner 38mm (included))
Battery not included Ro-Power 4S 2200mAh (not included)
Servo ELE not included 1x Robbe FS-166 BB MG #9105 (built-in)
Servo RUD / /
Servo AILE not included 2x Robbe FS-166 BB MG #9105 (built-in)
Servo FLAP / /
Servo cable
3x 25cm, 2x 15cm (JR) not
included
2x 15cm (JR)
MULITlock / /
MPX plugs / /
Adhesives
UHU Por, Adhesives, Activator
(not included)
UHU Por, Adhesives, Activator (not included)
TX min. 4 Channels (not included) min. 4 Channels (not included)
RX min. 4 Channels (not included) min. 4 Channels (not included)