Operating instructions

Page: 3
INSTALLATION
Remove all the packaging materials and tape, as well as any protective plastic from
the machine. Clean off any glue residue left over from the protective plastic or tape
using methylated spirit.
Place the mixer on a firm, level surface in the required position.
The DM21W, DM21R, DM21B & DM21C models plug into a standard, single phase,
10A Australian (Type I) power point.
The "-UK" models plug into a standard 13A United Kingdom (Type G) power point.
The "-F" models plug into a standard 16A European (Type E or F) power point .
We recommend the use of an RCD (Residual Current Device) rated at not less than
30mA for circuit protection when using these units.