Use and Care Guide

Switch removal

2. Unscrew two screws from the cover plate and remove it;

3. Unscrew the two screws on the switch cover plate, rotate and turn inside out the switch cover plate, pull out the switch

assembly and unplug the lamp connector terminal to repair or replace the lamp.

Unplug the power plug;

Removal steps:

1. Pull out the plug;

2. Unscrew the four screws from the back of the main hood panel.Tilt the panel forward to a certain angle, and then

pull it up forcibly;

3. Remove the drawing panel from the main hood panel;

4. Remove the sound absorption sponge first, and then use a cross screwdriver to unscrew the fastening screws on

acoustic baffle to remove the baffle;

5. Unscrew the fastening screws on the retaining ring to remove the retaining ring;

6. Unscrew the cap clockwise and take out the impeller vertically;

The installation steps are opposite to the removal steps.

(When you install the impeller, please rub some lubricating

oil on the shaft hole of it.)

Note: Step 3 is unnecessary if no drawing panel is installed.

Removal and installation of the whole body

1. Take down the oil cup with both hands at first;

2. 1.Aim the cross screwdriver at the screw hole and rotate counterclockwise about 90 degrees while slightly forcing up

the screwdriver, to remove one screw from the catch slot on one side of the hood. Then support the bottom of the mush

enclosure with one hand, and unscrew the other side with the screwdriver with the other hand;

3. 1.Hold the two ends of the mush enclosure with both hands, and pull in the direction as indicated by the arrow to take

it out.

Mesh Enclosure Removal

Range Hood