Use and Care Guide

The hood shall be cleaned and maintained regularly depending on the surroundings, so as to keep its cleanness &
efficiency and extend its service life.
We recommend that: Clean the outer surface of range hood after each cooking.
It is recommended to use a neutral detergent to clean instead of strong detergents, and dry with a soft cloth. If your
range hood is a mechanical switch, and should avoid the cleaning agent from contacting each control button.
Do not allow stains to stay on the surface of the hood for too long.
Please do not use cleaning balls, brushes and other rough objects to clean the hood
to prevent the body surface from scratching.
When cleaning or maintaining the hood, please wear protective gloves to prevent
wounding during wiping.
Please regularly check and clean the oil cup. Please check regularly
and clean the oil cup, hold the oil cup with both hands when the oil in the
oil cup is about to reach the tick mark. Shift out and remove the waste oil.
The range hood shall be started before cooking.
Please unplug it during long-term shutdown, but please do not pull hard.
Considerations
Removal of Components
1. As a general rule, the hood body does not need to remove, and removal shall be done by professional maintainers.
Nonprofessionals are forbidden to remove, install and repair the hood.
2. Before cleaning, installation or maintenance for the range hood, cut off the power supply to avoid electric shock.
Note: The installation procedures of the following components are in reverse with the removal. Please wear protective
gloves during operation to prevent the sharp edge of metal hurting your hands.
Warning
Tick mark
36
Lamp removal
1.
2. Embed a small flathead screwdriver or something sharp and small in the installation gap between lamp shade and
vessel hood, and force outward to take out the spotlight from the vessel hood;
3. Pull out the lamp connector terminal and replace the spotlight;
Unplug the power plug;
Lamp information
Lamp image
Lamp Type
Max Power
Voltage
Dimension
Rectangular LED
2W
12VDC
see the lamp image
2”(52mm)
10”(252mm)
1”(25.6mm)
Range Hood