Use and Care Guide

7. Pull the two supports of the attached panel of the mainframe with both hands and pull them upward, tear off the

protective film of the panel and the attached panel of the mainframe, and insert the attached panel of the mainframe

back along the gap between the panel of the mainframe and the shell.

up at the hitching leg on the wall at an angle, and use a level ruler to ensure that the machine is installed horizontally.

Fix the check valve on the range hood as shown in the figure, then lift the range hood and hang the back hook hole

pipe, and tighten the nut (to prevent the machine from decoupling accidentally under external force).

After the machine is installed in place, install the hitching leg stop block and the gasket on the M6 metal expansion

S 4.2×18

self tapping

screw

Check valve

seal

Junction

box

10 Attach the duct to the check valve and seal with aluminum tape,

and then plug it in.

Note: Please straighten the flexible aluminum duct when mounting, to

avoid noise generated when the flexible aluminum duct is semi-

stretched, and cut off the excess parts with wire pliers. The connection

between the air outlet pipe and the wall hole or the public flue must be

tightly sealed to ensure that the air outlet pipe is firmly connected with

the check valve or the public flue, and ensure that the blade at the

connection of the check valve or the public flue is opened and closed

flexibly.

2-2- /16”(50-55mm)

Ø /8”(10mm)

Range Hood