Use and Care Guide

3. Determine the positions to fix the hitching leg and the hitching leg stop block.
Note: The hitching leg must be fixed on the beam with a screw.
With the stove bearing surface as the base, mark the drill holes
in the corresponding position of the wall according to the
distance from the hitching leg hole to the bottom of the
machine, and the height of the bottom of the hanging cabinet.
The relevant size is given as below:
1). Range hood: the distance from the bottom of the machine
(the bottom of the cabinet) to the stove bearing surface is 25-
9 9
/16 -29- /16”(650-750mm);
2). Hitching leg: the distance from the center hole of the
1
hitching leg to the bottom of the machine is 20- /2”(520mm);
3). Hitching leg stop block: the distance from the hitching leg
stop block fixing hole to the center hole of the hitching leg is 2-
7
/16”(62mm).
3 3 5
4. 2- /8-2- /4”(60-70mm) /16”(8mm)
the expansion pipe into the hole, and reliably fix the hitching leg with 4×60mm wood screws supplied with the machine.
Use a level ruler to make sure the hitching leg is in a horizontal position.
Drill a hole deep (not too large) at the mark with a drill bit with a diameter of , press
Note: The hitching leg must be fixed to the beam with a screw.
30
5. Drill a hole with a diameter of (not too large) and a depth of at the fixing hole mark of
the hitching leg stop block, and insert the M6 metal expansion pipe into the hole.
3 3
/8”(10mm) 2-2- /16”(50-55mm)
1
2
1
4
16
10
12
1
4
1
6
1
0
Range Hood
2- ”
(62±2mm)
7
/16
3
/8”(10mm)
9 9
25- /16-29- /16”
(650-750mm)
2- ”
(55mm)
3
/16
2
(55mm)
3
- /16”
4- ”
(110mm)
5
/16
20- ”
(520mm)
1
/2
1 7
31- /2-35- /16”
(800-900mm)